Electric motor ALMO MTA 132 SX2 recon Ball bearings renewed from the rotor. Seals renewed. The engine has slight traces of smoke but is in an overhauled and installable condition. Data from the engine see pictures.
Viesse pump RB316BGT with electric motor recon Ball bearings renewed from rotor The pump was overhauled with the following new parts: - Impeller - Mechanical seal - Gasket set - Valve flap
6 cylinder covers MAK M20 The cylinder covers were equipped with the following new parts: - Inlet and exhaust valve guides. - On (20°) and exhaust valve seat rings (30°). - Inlet and exhaust valves. - Swivel devices. Nozzle sleeves were used with new sealing rings. Cylinder cover tested with 10bar water pressure. Round seals valve guide renewed. The sealing surface has been tested, is fine. Packed in wooden boxes. Price per piece
RECON rocker arms complete with rocker arms MAK M43C MAK Part Numbers: 433530-100, 433510-100, 433520-100
RECON valve bridge inlet and outlet MAK M43B and M43C MAK Part Number Inlet: 433515-100 MAK Part Number Outlet: 433515-200
2 pcs piston MAK M43C recon Piston crown new with LR test certificate. Piston shirt crack-tested approx. 35,000 operating hours. MAK Part Number: 432670-400
TWIN DISC MG514 marine transmission was built in Belgium. The device working with high- or medium-speed diesel engines used in, for example, tugs or ferries, optimises the control of engine power to increase overall cost-effectiveness, productivity and boat performance. The TWIN DISC MG-514 transmission operates at a rotational speed of 1800 rpm with a ratio of 2.00:1 and has 360 HP of power. The machine comes from an engine in very good condition with which it has worked for a small amount of time. The offered device is fully complete. The total weight of the machine is 525 kg. Technical data of the TWIN DISC MG514 transmission - ratio: 2.00:1 - power: 360 HP - maximum rotational speed: 1800 rpm - oil capacity: 23 l - minimum oil pressure while cruising: 13 bar - overall dimensions (L x W x H): 80 x 80 x 80 cm - total weight of MG514 machine: 525 kg
TWIN DISC MG514 transmission was manufactured in Belgium. Used on high- or medium-speed diesel engines, the machine significantly increases overall boat efficiency and productivity by optimising the control of engine power. The offered TWIN DISC MG-514 marine transmission with a power of 360 HP operates at a rotational speed of 1800 rpm and has a ratio of 2.00:1. A fully complete machine with low mileage, has been used on an engine in very good condition. The total weight of the machine is 525 kg. Technical specifications of the TWIN DISC MG514 marine transmission - ratio: 2.00:1 - power: 360 HP - speed: 1800 rpm - oil capacity: 23 l - minimum oil pressure while cruising: 13 bar - dimensions (L x W x H): 80 x 80 x 80 cm - weight of the MG514 machine: 525 kg
SEW Eurodrive electric motor Fully functional
2015 Manufacture Date 0 hours since manufacture Stored continuously been stored indoors a temperature-controlled building since delivery (still crated) 7901S Taurus 60 (SoLoNOx) 5670/kWe Generator 13800 Volt 60 HZ (1800 RPM) 3 Phase No enclosure, open skid TURBOTRONICS PLC 4 with TT4000 Display FAT tested by Solar Turbines VFD start system Complete Air inlet filtration system Complete site (equipment) inspection performed by Solar 2019
Inv. Num. : 6597 Type: AS275 Producer: AOSIF ENGINEERING LTD Created: 2022 Parameters: Throughput speed: 1500 1/min Frequency: 50 Hz Voltage: 380 V Machine dimensions: 1578x778x1290 mm Weight: 2800 kg
SUMAB is currently offering a horizontal steam generator. Technical details: Capacity 1500 kg/h, allows you to produce steam in a short period of time. Pre-installed accessories are ready to run. A two part platform for easy assembly on site. Includes: water softening device, condensate tank, cavitation preventing pump, by-pass group with float trap, all fittings and piping connections.
Generator E motor with control cabinet only 225 B hours A van Kaick Weight engine approx. 800 kg Control cabinet approx. 50 kg Delivery possible Please inquire with place and postcode and whether there is unloading possibility.
Gear motor Flender MBH 125CC-B 27.7/1 Bevel helical gear drive motor 11 kW at 1400 1/min. 230/400 V, 50 Hz, IP 55 were operated with frequency converters Matching Freqenzumrichter Walther Flender ZZ0103069.34003 Sinus Penta available A total of 15 traction motors and 12 drives !!! available Very good condition, straight from production!!!
For sale is a whole heating system installed in the container, all ready with custom-made chimney. Technical inspection was carried out by Dekra. The heater has only 16 hours of operation behind it, so it's almost like new. Incl. Weihaupt light oil burner, incl. heating oil tank, 5t incl. fireplace system, incl. mixed cooler, incl. condensate management for steam generators up to 1bar, incl. Additional equipment: condensate tank, incl. pipe separator + backwash protection filter + Single water softener VAD 25, incl. Dosing station and accessories, incl. Insulated sheet steel container Can be visited in Mölln. Technical data can be found in the pictures. Sale only to self-collectors, if you have any questions, please contact us.
Make and Model: Heliex HP145 110, HP204 630 Year: 2017 Hours : 0 Capacity kW: 110, 630 HZ : 50/60 Voltage: 400/480 V Condition: It is as new. Has had basic commissioning only. Extra: Ambient temperature: -10°C to +45°C, Ambient humidity:
TRIOGEN E-BOX ORC for sale. Model: E-BOX ORC Year: 2017 Hours: 0 Capacity: 170 kW Hz: 50 Voltage: 400 V Scope of supply: Complete ORC E-Box. The E-Box is primarily an E-Box 170kWe Power, but can be also an E-Box 170 CHP (Vario). General Information: E-Box 170 Power – this is when the working fluid condensing (cooling) temperature is at 55degC, this is specific to recovering hot gas at around 500degC (engine exhaust for example). To achieve full power (170kWe gross), the cooling water needs to operate at 55degC, this generating maximum power of 170kWe refer to graph given at cooling temp of 55degC = 170kWe. Price: £240,000