ID2927 Complete limestone processing plant Complete limestone processing plant consisting of: • pre-crushing plant – approx. Year of construction 1970 • Primary crusher impact mill Hazemag AP5, capacity up to 500 t/h • Secondary crusher impact mill Hazemag AP4 – approx. year of construction 1970 • Gravel plant 300-350 t/h – year approx. 1983 • Fine crusher impact crusher SBM 10/6/4 EXP – year 1993 • Fine chippings plant 350 t/h – year 1996 • with feed hopper, pusher truck feeder, roller grates, silos, screening plants, conveyor belts, dedusting, etc. • Control new in 2018, loading control new in 2020 Complete limestone processing consisting of: • Pre-crushing plant - approx. built in 1970 • Hazemag AP5 primary crusher impact mill, capacity up to 500 t/h • Secondary crusher impact mill Hazemag AP4 – approx. built in 1970 • Ballast mill  ...

ID2955 Key Maker Magic 1211 year/Year of construction 1984 Manhole finisher, 1 piece Magic 1211, with 2 Atlas 300 + 400 molds, 2 palisade molds, 1 built-in mold, 1 vibrator incl. FU, various base sleeves Shaft paver, 1 piece Magic 1211, with 2 pieces of moulds Atlas 300 + 400, 2 pieces of mould palisades, 1 piece of mould installed, 1 piece of vibrator incl. FU, various lower sleeves

Ground paver Knauer TYPE Komet 104 C built in 1980. Manual machine for small quantities or trial productions. Stone height maximum 50 cm For hollow blocks, chimney blocks, lightweight concrete blocks, etc. Very robust machine, with manual hydraulic control. The electrics are very simple and easy to repair. The machine is ready for operation and was still used for special stones until the introduction of a new fully automatic machine. It is well maintained. However, all guides and drives are in order and well lubricated. Without mold shaker and mold, these are in the photo, but are not included. Spare parts are also still available and could be purchased at the time of sale.

Used sand-lime brick press, hydraulically working, two-sided compaction, 195 kW install. Power, control S5, max. pressing force approx. 10,000 kN, max. pellet height 650 mm, for the production of sand-lime brick blocks and elements, fully automatic operation, plant still in operation – visit possible

Sand-lime brick press, hydraulically working, Fabr. Dorstener HDP800 N (left-hand version), with two-sided compression, 190 kW install. Power, control S5, max. pressing force approx. 6,000 kN, max. pellet height 300 mm, for the production of sand-lime brick blocks, fully automatic operation, system is dismantled and stored in a dry place

Landfill conveyor belt 650 x 23 m galvanized, with supports, walkway, hinge cover Good condition Also available and mounted  ... más información

IFE Circular Vibrating Screening Machine Screen width 2 m Screen length 5 m 2 Decks Plastic exchange system WS 85 or similar Machine ran in limestone little wear and few hours With sieve funnel and stand-up feet  ... más información

Slicer IFE 2 x 5 m 1 Deck Version Screen lining, wire cross-tensioned Very good condition, few operating hours from a pilot plant  ... más información

2 PCs unused humidity probes for mixer Original spare parts for a love Mr of ZE 2000  ... más información

Impact crusher Pozzato 8-5-3 Machine width 500 mm Rotor diameter 800mm, 3 impact bars Capacity up to 40 t/h Feed size approx. 50 mm Sand content in the crushing product up to 50% Machine on base frame Older year of construction with very few operating hours  ... más información

Split sieve coverings for an IFE dewatering screening machine 1 pcs L 500 mm x W 800 mm gap 0.3mm 1 pcs L 1000 mm x W 800mm gap 0.3 mm 2 pcs L1000mm x W 800 mm gap 0.3 mm 3 pcs L1000mm x W 800 mm gap 0.3 mm 5 pcs L1000mm x W 800 mm gap 0.3 mm The pads are unused or only in use for a short time

Drum screening machine for the production of humus or similar Wheel Loader Feed Hopper Ascending band Drum sieve with brush approx. 1.x4m  ... más información

2 cyclones as good as new Type AKA VORTEX Twin TRT 4118 Throughput per twin 95m3/h total 190m3/h Diameter 200mm, cutting cut approx. 50my 1 pcs new cyclone Type AKA Vortex KRS3128 II 40m3/h DM 150 mm All cyclones including overflow line and shut-off valve If required, a refurbished PUMP METSO VASA is also available Drive 30 kW available are also handed in individually

Flender drive gearbox from a tunnelling conveyor belt mill Gearbox, output speed approx. 44 rpm (1.5 m/s with drum diameter 630mm) Drive motor 75 kW Turbo clutch  ... más información

Conveyor belt tensioning drum with shaft Diameter 830mm Drum width 1300 mm for conveyor belt 1200 mm  ... más información

Dosing conveyor belt Belt width 500 mm Wheelbase 2500mm Drum diameter 220mm Drive drive drive north 1.1 kW, 0.12 m/s Spindle clamping device Strap EP250 3 3+2 galvanized version Leitgosse Intrusion protection Ripcord switch  ... más información

Pre-breaker with crusher Suitable for soft lime, marl, coal Power up to 200- 600 t/h Task size up to 1500mm Drive - electric transformer station 30kV/400V Drive power approx. 500 kVA Plant weight approx. 130 tons Task bunker 25m3 Chain conveyor Roller rust Schlagwalzenbecher Deduction tape Dust removal system Caterpillar suspension - not self-driving Conveyor belt 3 x 40m Telestack, self-driving, belt width 1200mm Immediately available

Compact filter plant McCloskey new! Screening plant for the GALA of construction, agriculture Mobile system area ca 2 m2 2 screen decks  ... más información

Inlet: 1,440 x 900 mm Rotor diameter x width: 1,250 x 1,420 mm new wear lining ... más información

This machine can be considered as an ultimate solution for the production of concrete elements providing the one to choose numerous options as an additional upgrade to the machine that can make production even more efficient: Filling box on servo drives Filling boxes both from the coarse mix and face mix powered with 2 servo motors create fast movement back and forth contributing reliable filling of the mould. As for the coarse mix device filling box it is additionally equipped with an agitator (driven by the hydraulic cylinder) for equal and fast filling. Servo vibration Hi-dynamic Servo vibration system transmits power for the high compaction with the just right consumption of electrical power to vibration table consisted of impact and ledge bars and thus providing top-quality paving stones, blocks, curbstones as well as any other products which modern demanding market require ...